Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 44 / 500

3. SIGNALS AND WIRING
3 - 11
2) Inserting the wire
Insert the open tool as shown in the following figure, and push down the open tool to open the spring
hole. The open tool has protrusions for the CNP1 (large size) on one side and those for the others
(small size) on another side. While the open tool is pushed down, insert the stripped wire into the
wire insertion hole. Check the insertion depth so that the wire sheath does not get caught by the
spring. The following shows a connection example of the CNP1 connector.
Open tool
Wire insertion hole
3) Securing the wire
Release the open tool, and secure the wire. Pull the wire lightly, and check that the wire is connected
firmly.