Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 114 / 500

5. PARAMETERS
5 - 27
5.5 Option setting parameters (No.Po
)
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
5.5.1 List of parameters
No. Symbol Name
Setting
(Note 1)
Factory
setting
(Note 2)
Unit
Po01 *OOP1 Function selection O-1 Common 0000h
Po02 SGRA Axis selection for graphing analog data (MR Configurator) Common 0000h
Po03 SGRD Axis selection for graphing digtal data (MR Configurator) Common 0000h
Po04 **OOP2 Function selection O-2 Common 0000h
Po05 This parameter is not used. Do not change the value. 0000h
Po06 0000h
Po07 0000h
Po08 0000h
Po09 0000h
Po10 0000h
Po11 0000h
Po12 0000h
Po13 0000h
Po14 0000h
Po15 0000h
Po16 0000h
Note 1. Each axis: Set a value for each of the A-axis and the B-axis.
Common: Common parameters for the A-axis and the B-axis. Set same values for the A-axis and the B-axis. If different values are
set, the last set value becomes valid.
2. Valid for the A-axis and the B-axis.