Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 88 / 500

5. PARAMETERS
5 - 1
5. PARAMETERS
CAUTION
Never adjust or change the parameter values extremely as it will make operation
instable.
When the fixed values are indicated for any digits of a parameter, never change the
values of the digits.
POINT
When the servo amplifier is connected with the servo system controller, the
parameters are set to the values of the servo system controller.
Setting may not be made to some parameters and ranges depending on the model
or software version of the servo system controller. For details, refer to the servo
system controller user's manual.
In this servo amplifier, the parameters are classified into the following groups on a function basis.
Parameter group Main description
Basic setting parameters
(No.PA
)
Make basic setting with these parameters. Generally, the operation is possible only with these
parameter settings.
Gain/filter parameters
(No.PB
)
Use these parameters when making gain adjustment manually.
Extension setting parameters
(No.PC
)
When changing settings such as analog monitor output signal or encoder electromagnetic brake
sequence output, use these parameters.
I/O setting parameters
(No.PD
)
Use these parameters when changing the I/O signals of the servo amplifier.
Extension control parameters
(No.PE
)
Use these parameters when selecting a function in the fully closed loop system.
Option setting parameters
(No.Po
)
These parameters are dedicated to MR-J3W.
Mainly setting the basic setting parameters (No.PA
) allows the setting of the basic parameters at the time of
introduction.
5.1 Basic setting parameters (No.PA
)
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.