Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 377 / 500

14. USING A DIRECT DRIVE MOTOR
14 - 44
Alarm No.: 11 Name: Switch setting error Stop system: All axes
Alarm content
Rotary axis setting switch was incorrectly set.
DIP switch was incorrectly set.
Servo motor selection switch was incorrect set.
Display Detail name Cause Check method Check result Action
11.1 Rotary switch
setting error
Same as for the rotary servo motors.
Refer to section 8.3.
11.2 DIP switch
setting error
11.3 Servo motor
select switch
setting error
11.4 Servo motor
select switch
setting error 2
Alarm No.: 12 Name: Memory error 1 (RAM) Stop system: All axes
Alarm content
A part (CPU) in the servo amplifier is failure.
A part (custom IC) in the servo amplifier is failure.
Display Detail name Cause Check method Check result Action
12.1 CPU built-in
RAM error
12.2 CPU data RAM
error
12.3 Custom IC
RAM error
Same as for the rotary servo motors.
Refer to section 8.3.
Alarm No.: 13 Name: Clock error Stop system: All axes
Alarm content
Fault was found in the printed board.
A clock error transmitted from the controller occurred.
Display Detail name Cause Check method Check result Action
13.1 Clock error Same as for the rotary servo motors.
Refer to section 8.3.
Alarm No.: 15 Name: Memory error 2 (EEP-ROM) Stop system: All axes
Alarm content A part (EEP-ROM) in the servo amplifier is failure.
Display Detail name Cause Check method Check result Action
15.1 EEP-ROM error
at power on
15.2 EEP-ROM error
during
operation
Same as for the rotary servo motors.
Refer to section 8.3.