Mitsubishi Electric MELSERVO-J3W Series, Instruction Manual

Page: 294 / 500

13. USING A LINEAR SERVO MOTOR
13 - 45
13.6.4 Extension setting parameters (No.PC
)
(1) Parameter list
POINT
The parameter whose symbol preceded by * can be validated with the following
conditions.
* : Turn off the power and then on again, or reset the controller after setting the
parameter.
**: Turn off the power and then on again after setting the parameter.
No. Symbol Name
Setting
(Note 1)
Factory
setting
(Note 2)
Unit
Reference
PC01 ERZ Error excessive alarm level Each
axis
0 mm This
section
(2)
PC02 MBR Electromagnetic brake sequence output Each
axis
0 ms Section
5.3.2
PC03 *ENRS Encoder output pulses selection Each
axis
0010h
PC04 **COP1 Function selection C-1 Each
axis
0000h
PC05 **COP2 Function selection C-2 Each
axis
0000h
This
section
(2)
PC06 *COP3 Function selection C-3 Each
axis
0000h
PC07 ZSP Zero speed Each
axis
50 mm/s
Section
5.3.2
PC08 This parameter is not used. Do not change the value. 0
PC09 MOD1 Analog monitor 1 output Common 0000h
PC10 MOD2 Analog monitor 2 output Common 0001h
PC11 MO1 Analog monitor 1 offset Common 0 mV
This
section
(2), (3)
PC12 MO2 Analog monitor 2 offset Common 0 mV
PC13 Do not use it in a linear servo. 0
PC14 0
PC15 SNO Station number selection Common 0 Section
5.3.2
PC16 This parameter is not used. Do not change the value. 0000h
PC17 **COP4 Function selection C-4 Each
axis
0000h Section
5.3.2
PC18 This parameter is not used. Do not change the value. 0000h
PC19 0000h
PC20 0000h
PC21 *BPS Alarm history clear Each
axis
0000h Section
5.3.2
PC22 This parameter is not used. Do not change the value. 0000h
PC23 0000h
PC24 0000h
PC25 0000h
PC26 0000h