IAI Rcon, Instruction Manual, Page: 259 / 838

3.9 Gateway Parameter Configuration Tool
A3-156
ME0384-4A
Chapt
er 3 G
at
eway
Uni
t
Spec
ific
at
ion
s S
ec
tion
Special parameter setting function descriptions
[GW parameters]
• ERR_T/C occur latch : Selects whether to continue the error in recoverable
state after ERRT and ERRC occur.
• SERVO-OFF in ERR_C : Selects whether to turn the servo of the connected
axis OFF when ERRC is generated.
• Speed unit (in direct numerical control mode) : Selects the speed unit from 1.0 mm/s or 0.1 mm/s.
• Internal communication retry count
: In AUTO, this is used to set the number of
communication retries with the connected axis.
• MON signal : Select whether to use MON signal to control
enable/disable of the PLC → gateway unit
commands.
[GW parameters 2]
• Calendar function : Selects whether to set an alarm or not when the time setting disappears.