9
9
9-285
9-285
Installation > [TYPE-8] > Installation Procedure > Installing the Mirroring Board or Encryption Board
Installation > [TYPE-8] > Installation Procedure > Installing the Mirroring Board or Encryption Board
CAUTION:
• When fixing the cables with wire saddles, be sure to take up slack of them at [A] part,
and slack off them at [B] part.
• If slacking off the cables at [A] part, they may interfere the fan on the host machine
when returning the Controller Box.
Wire Saddles
[A]
[B]
F-9-764
CAUTION:
Be sure to acknowledge the following caution before performing the next procedure.
Combinations of connection between the HDDs and the Mirroring Board or Encryption
Board are shown below.
• Connect Slot 1 to "CHA". (Originally installed HDD)
• Connect Slot 2 to "CHB". (New HDD)
Slot.2 (HDD2)
Slot.1 (HDD1)
CH A
CH B
Power Cable
Signal Cable(Red)
Signal Cable(Blue)
Power Cable
F-9-765
9) Connect the cable of the HDD Drawer Unit to the Mirroring Board or Encryption Board.
Power Cable
from front side
Power Cable
from rear side
Signal Cable(Red)
Signal Cable(Blue)
x4
10)
Place the Controller Box to the original position. (2 Screws or 3 Screws)
11)
Affix the Shutdown Caution Label in the appropriate language on the Right Rear
Cover 1. (Included in the Removable HDD Kit).
F-9-766
F-9-767