Autodesk LIGHTSCAPE, Manual

Page: 278 / 362

Batch Processing Utilities B
270
Lightscape
LSM2T Syntax Example
This command loads the Solution file room.ls and applies the “Convert each surface to a texture per surface”
conversion method. The existing textures on the model’s geometry are replaced, the mesh is reset, and the
resulting Solution file is saved as output.ls. A series of 128 x 128 texture files are generated using the filename
txtr.jpg combined with an incremental three-digit number for each successive file. The generated images are
antialiased (level 3).
lsm2t -aa 3 -replace -reset -method convert -x 128 -y 128 -o output.ls
room.ls txtr.jpg
-proj
cylindrical
orthographic
spherical
uvs
Projection method. Default = orthographic.
-rb n Number of reflection bounces to trace. Default is 10.
-replace Replace textures on target geometry.
-reset Reset mesh on target geometry.
-sh Recompute shadows from lights and sun.
-soft Compute soft shadows (for sun only).
-v Verbose. Show status messages.
-x n Width of new texture images. Default is 128.
-y n Height of new texture images. Default is 128.
Where: Indicates:
-aa 3 Level 3 antialiasing.
-replace The textures that exist on the target geometry are replaced with the new textures.
-reset The mesh on the target geometry is reset.
-method convert The “Convert each surface to a texture per surface” conversion method is used.
-x 128 The output images are 128 pixels wide.
-y 128 The output images are 128 pixels high.
-o output.ls The output Solution file is output.ls.
Room.ls The input Solution file is room.ls.
Option: Extension: Description: