SeeMeCNC Rostock MAX v2, Инструкция по сборке

Страница: 82 / 314

Rostock MAX v2 Assembly Guide
Pull enough of the 18ga wire so that the end coming out of the “top” comes within about 6” of
the “bottom” of the tower. This will give you plenty of room for wiring up the hot end.
Now you'll route the end stop wires. Carefully stretch out the three wire pairs included in the
bundle and spindle the ends together as shown in Fig. 6-4.
Now thread the bare wire you recovered from the 18ga, 4 conductor cable through the center of
the next tower. When you've pulled it all but about four inches, wrap the wire around the spindled end
of the end stop wires as shown below.
82
Fig. 6-4: End Stop wires bundled together.
Fig. 6-5: Bundle ready to pull.