SeeMeCNC Rostock MAX v2, Инструкция по сборке

Страница: 81 / 314

Rostock MAX v2 Assembly Guide
The 18ga, four conductor cable is the first one we're going to use. When you're done stripping
it, you should have something like this:
Take one of the aluminum extrusions and thread this wire right through the small channel in the
center of the tower. Turning the wire counter-clockwise will help this process along.
When you're done, it should look like the image shown below.
Because the 18ga wire is pretty stiff, you should be able to run it inside the tower pretty easily.
Just do it an inch at a time to take advantage of the greater stiffness afforded over a shorter length of
wire. If you're unable to do it, you can skip ahead to the next page and see how the bare wire you
saved is used as a “fish” wire.
81
Fig. 6-2: 18ga wires.
Fig. 6-3: 18ga wires routed.