NEC SV8500, Руководство пользователя

Страница: 1918 / 3438

VOL.2-1665
MG-SIP96
(51) sip_route
Setting of the route information of SIP network
This command is used to specify route information in the SIP side network.
Use “set sip_route” command.
For details, see “
ipx_route ”(Setting of the route information in the Telephony Server network).
Note:
When IPv6 (=1) is selected by “set ip_version” command since SP-3987 MGSIP PROG-B Issue 3,
the IP address of the router is assigned to the default gateway automatically. If you attempt to ex-
ecute this command, the following message appears:
“Sip route data can not be set when IPv6 is enable.”
(52) sip_rtp_port_no
Setting of the RTP base port number of SIP network
This command is used to specify the RTP base port number from SIP network. (Even numbers only.)
[Setting Example]
Note:
The conditions of this command are as follows.
• Normally this command is not required to be changed.
• The system uses 192 (96
×
2) consecutive port numbers from the RTP base port number.
• If you select one port in the number of port setting, be careful not to use the same RTP port number (set by
“set sip_rtp_port_no” or “set ipx_rtp_port_no” command) when setting the non-default SIP network RTP
base port number.
(53) sip_server
Setting of the information of SIP server
This command is used to assign an IP address or a Fully Qualified Domain Name (FQDN), and port num-
ber, type, and SIP domain of the SIP server.
The following figure shows an example of display.
When IP address (=0) is selected:
[IPv6]
MG(SIP)> set sip_rtp_port_no
Input SIP side RTP Port Number.
(1024-64000(default=50000)):50000
Assign the RTP base port number for SIP side
(Default: 50000)
(Receiving side of MG-SIP96)
MG(SIP)> set sip_server
Select SIP server type.
0=IPAddress(default)
1=FQDN
Input:0
When IP address (=0) is selected.
(Default: 0)