NEC SV8500, Руководство пользователя

Страница: 2512 / 3438

VOL.3-25
CHAPTER 1 TERMINALS
<Service Conditions>
(1) Firmware upgrade of supported terminal is necessary to operate this feature. Behavior when terminal is
connected without the firmware upgrade is shown in the table below.
Behavior of terminal before and after the firmware upgrade
X = Available with factory setting
C = Conditionally available (Bit switch setting is required)
N = Not available
(2) LCD can display the name data assigned to each key by receiving data from the system.
(3) Confirmation tone is available.
(4) Available to connect to Non-IP terminal or IP terminal, setting needs to be done with the bit switch when
connecting the IP terminals. Refer to the table above “Terminal connectability” for detailed explanation of
supported terminals.
(5) The display contrast of the LCD can be changed either by two adjustment button of the 16LD ADM itself
or by the volume control button of the telephone side. (except for INASET 320G)
(6) Tilting and wall mounting is available.
(7) Terminal back-light function is not supported.
(8) Low-power consumption mode is not supported.
(9) 16LD ADM firmware can be upgraded by connecting to PC via USB port.
(10) When there is no phone book function, phone book feature cannot be provided by pressing the DIR/EXIT
button.
(11) Maximum numbers of 16LD ADM to be accommodated per system is 4096. (4096 per node when FCCS
network is used.)
Item
Non-IP terminal
IP terminal
(Includes INASET)
Before F/W
upgrade
After F/W
upgrade
Before F/W
upgrade
After F/W
upgrade
Basic operation (16 button addition and LCD data
display)
X X N X
Confirmation Tone N X N X
Firmware upgrade X X X X
Contrast adjustment (link operation by the side of
terminal)
N X N X