NEC SV8500, Руководство пользователя

Страница: 1469 / 3438

VOL.2-1216
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
6. SET
Δ
DRSADDRESS
This command is used to specify IP address for DRS.To make this assignment effective, it is required to
execute the “SAVE” command and to restart before exiting the maintenance command.
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
7. SET Δ DRSQOS Δ [ P1 ] Δ [ P2 ]
This command is used to specify Quality of Service (QOS) such as IP Precedence and Differentiated Ser-
vice (DIFFSERV) for DRS. To make this assignment effective, it is required to execute the “SAVE” com-
mand and to restart before exiting the maintenance command.
When P1 is not entered:
MG-PRI(SIP)>SET DRSADDRESS
DRS Unit (1:Primary/2:Secondary/3:Tertiary/4:Fourth):1
DRS IP Address: 150.12.0.254
DRS Port Number: 3456
1) Select the applying type for DRS
1 =Primary
2 =Secondary
3 =Tertiary
4 =Fourth
2) Specify IP address Note 1
3) Specify port number of DRS
(default: 3456)
DRS setting succeeded.
Result is displayed.
MG-PRI(SIP)>SET DRSQOS TOS 0xC0
P1 -Specify a type of services
TOS : IP Precedence
DIFFSERV : Differentiated Service
CLEAR : Clear the data
P2 -Specify a value
0x00-0xFF (In the case of TOS)
0-63 (In the case of DIFFSERV)
MG-PRI(SIP)>SET DRSQOS
QOS (TOS/DIFFSERV:TOS):TOS
1) Specify TOS for QOS
PRECEDENCE (0-7:6):6 2) Specify precedence (Default: 6)
0-7 (low-high)
DELAY (0/1:0):0 3) Select a type of delay (Default: 0)
0/1 =Normal/Delay
THROUGHPUT (0/1:0):0 4) Select a type of throughput (Default: 0)
0/1 =Normal/High Throughput
RELIABILITY (0/1:0):0 5) Select a type of reliability (Default: 0)
0/1 =Normal/High Reliability
COST (0/1:0):0 6) Select a type of cost (Default: 0)
0/1 =Normal/Cost Precedence
DRS QoS setting succeeded.(0xC0) Result is displayed.