NEC SV8500, Руководство пользователя

Страница: 1897 / 3438

VOL.2-1644
MG-SIP96
Note:
If you select one port in the number of port setting, be careful not to use the same RTP port number
(set by “set sip_rtp_port_no” or “set ipx_rtp_port_no” command) when setting the non-default
SIP network RTP base port number.
(26) ip_version
Setting of SIP side IP Version
This command is used to specify the IP version for the SIP side network.
[Setting Example]
Note:
The conditions of this command are as follows.
• This command is available for SP-3987 MGSIP PROG-B Issue 3 or later.
• After changing the IP version with this command, you also need to change the IP addresses configured with
the following commands before executing the “reboot” command.
- “DNS IP address” configured with “set dnsaddress”
- “SIP server IP address” configured with “set sip_server”
- “SIP register IP address” configured with “set sip_register”
When you change IPv4 to IPv6, IP address for Ether2 port configured with “set ipaddress” is generated by
MG-SIP96 after receiving the RA message.
• When you change the IP version with this command, see also the information in 19.5.3 IPv6 Function .
(27) ipx_route
Setting of the route information in the Telephony Server network
This command is used to specify route information in the Telephony Server side network. The registered
number of the route information is up to 10.
The following figure shows an example of display.
When Route type = 0 is selected:
MG(SIP)> set ip_version
Select the setting of SIP side IP
Version.
0=IPv4 (default)
1=IPv6
Input: 1
Assign the IP version for the SIP side network.
0: IPv4 (Default)
1: IPv6
MG(SIP)> set ipx_route
Select Route type(0:Exit/1:None/2:Static):0 0: Exit
1: None (Default)
2: Static
Select “0”.
MG(SIP)> Exit the command without executing any-
thing.