NEC SV8500, Руководство пользователя

Страница: 1756 / 3438

VOL.2-1503
MG-SIP128 [MG-128SIPMGJ]
(23) interface
Setting of the operation speed and operation mode of an interface
This command is used to assign the Ether speed and the duplex type to each port on MG-SIP128 [MG-
128SIPMGJ].
[Setting Example]
Note 2: When “Automatic Negotiation” is selected, “AUTO” is automatically applied to the interface.
Therefore, this command line will not appear for interface that is specified as “Automatic Negoti-
ation”.
Note 3: When100Mbps (fixed) is selected, “Full Duplex” is automatically applied to the interface. There-
fore, this command line will not appear for interface that is specified as “100Mbps (fixed)”.
Note:
Normally this command is not required to be changed.
(24) ipaddress
Setting of IP address and subnet mask
This command is used to set the number of ports MG-SIP128 [MG-128SIPMGJ] uses, and assign an IP
Address and a subnet mask to each Ether port on MG-SIP128 [MG-128SIPMGJ].
Ports of MG-SIP128 [MG-128SIPMGJ] are allocated as follows;
• Ether1: LAN (Telephony Server network) side
• Ether2: WAN (SIP network) side
MG(SIP) > set interface
Select Ether[1] speed.
0=AUTO(default)
1=10M
2=100M
3=1000M
Input:0
Assign an Ether speed type to Ether 1.(Example:
when AUTO is set.)
0=Automatic Negotiation (Default)
1=10 Mbps (fixed)
2=100Mbps (fixed)
3=1000Mbps (fixed)
Note 3
Select “0”. Note 2
Select Ether[2] speed.
0=AUTO(default)
1=10M
2=100M
3=1000M
Input:1
Assign an Ether speed type to Ether 2.(Example:
when 100M/Full is set.)
0=Automatic Negotiation (Default)
1=10Mbps (fixed)
2=100Mbps (fixed)
3=1000Mbps (fixed)
Note 3
Select “1”.
Select Ether[2] duplex.
1=Half
2=Full
Input:2
Assign a duplex type to Ether 1 and Ether 2.
1=Half Duplex
2=Full Duplex
Select “2”.