NEC SV8500, Руководство пользователя

Страница: 1565 / 3438

VOL.2-1312
MG-T1(SIP) [SCA-24DTIA]
Note 1:
About IP address of SIP server (Telephony Server), refer to “Registration Destination of IP Devices/Sta-
tions” in INTRODUCTION of Installation Manual.
F
Setting communication speed of LAN interface:
F
Save the assigned configuration data at the last of SETUP SP command to complete network setting:
2. SETUP Δ T1
This command is used to set up T1 interface data for MG-T1(SIP).
F
To start up SETUP T1 command:
Continue? [Y (continue)/N (exit)]: n
Asked whether to continue the setting of other
SIP servers.
Y: Continue to register other Telephony Servers
N: Exit this setting and move on to the next step
--- Ethernet Speed set ---
Current LAN Speed: auto
The current setting is displayed.
Change LAN Speed? [Y (change)/N (current)/Q(quit)]:
y
Asked whether to change the displayed setting.
Y: Change the setting
N: Remain the current setting
Q: Exit this setting
Input new Speed [1 (AUTO)/2 (100M)/3(10M)]: 2
Select the communication speed of LAN inter-
face.
1: Auto negotiation (default)
2: 100Mbps fixed mode
3: 10Mbps fixed mode
Input new DUPLEX [F (full)/H (half)]: f
Select duplex mode of LAN interface.
F: Full Duplex mode
H: Half Duplex mode
(*Not displayed when auto negotiation is
selected.)
** Don't power off in progress **
Do you save the configuration data? [Y/N]: y
Asked whether to save the assigned data.
Y: Save
N: Discard
Configuration data has been saved.
Re-starting is required for making a setup reflect!!
Result is displayed.
SP mode setting succeeded.
MG-T1(SIP)>
MG-T1(SIP)> SETUP T1
Enter “SETUP T1” following the prompt.