NEC SV8500, Руководство пользователя

Страница: 806 / 3438

VOL.2-553
MG-COT Card [SCA-6COTA/SCA-6COTC]
• When DHCP server is NOT used
Set the following data on MG-COT Card.
• IP address of Default Gateway
• IP address and port number of DRS
Note 1
• IP address of MG-COT Card (own address)
Note:
When the DHCP is set to “ENABLE”, IP addresses assigned here cannot take effect. Be sure to assign
“SET DHCP DISABLE” before starting the IP address setting.
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
Note:
Write down the displayed MG-ID (MAC address of MG-COT Card) to assign the MAC address on PCPro
command AMGIL and AISTL.
Note:
The value in [ ] shows the current setting. Press enter key to apply the current setting show in [ ].
MG-COT> setup tp
Input “setup tp” and press Enter key. Note 1
MG-ID = xx:xx:xx:xx:xx:xx MG-COT Card’s MAC address is displayed.
Use DHCP?
Input (Y:Yes / N:No / Q:Quit) : n Set whether to use DHCP server.
Input “n” here and press Enter key.
OWN IP ADDRESS [0.0.0.0] : 1.1.1.10
Input the IP address of MG-COT Card.
SUBNET MASK [255.255.255.255] :
255.255.255.0
Input the Subnet Mask of MG-COT Card.
DEFAULT GATEWAY [0.0.0.0] : 1.1.1.254
Input the Default Gateway of MG-COT Card.
DRS1 ADDRESS [0.0.0.0] : 1.1.1.1
Assign the IP address of DRS. Note 2
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = DISABLE
OWN IPADDRESS = 1.1.1.10
OWN SUBNETMASK = 255.255.255.0
DEFAULT ROUTE = 1.1.1.254
DRS1 ADDRESS = 1.1.1.1
--------------------------------------
Input (Y:OK / N:Change / Q:Quit) : y Confirm the assigned data. Input “y” and press Enter
key. The assigned data is automatically saved and start
rebooting. The data turns effective after rebooting the
MG-COT Card.