NEC SV8500, Руководство пользователя

Страница: 1766 / 3438

VOL.2-1513
MG-SIP128 [MG-128SIPMGJ]
[Setting Example]
Note: When the “set mp_mode” command has been assigned, be sure to reboot MG(SIP) before assigning
the “set mp_data” command.
(30) mp_refresh
Refreshing of the Multipoint data table
The command is used to refresh the Multipoint data table.
[Setting Example]
Note: When refreshing of the Multipoint data table is failed, the number and the details (up to 10) of error
are displayed on the console. Then, Error Code is written into CSV file.
(31) multi_regist
Setting of the registration function per number
This command is used to enable/disable the setting of registration to SIP server per number.
MG(SIP) > set mp_mode
Select the setting of Multipoint mode.
0 = disable (default)
1 = enable
Input:1
0: Multipoint mode is disabled
(This setting is finished without
setting Search Number digits
and Server Priority)
1: Multipoint mode is enabled
(This setting is finished after set-
ting Search Number digits and
Server Priority)
If you change Number of Search Number digits,
update mp_data file after reboot.
Input Number of Search Number digits.
(1-8 (default=7)) : 7
Assign the digits of Search
Number.
Select Server Priority.
0 = Fixed (default)
1 = Round Robin
Input:0
0: Address that is assigned to
Primary for Multipoint data table
is prioritized
1: Address is determined by
Round Robin method
MG(SIP) > set mp_refresh
This command writes mp_data file to a memory.
Are you sure?(y/n): y
mp_data file load start...
To refresh the Multipoint Data
Table, enter “y”.
mp_data file load end.