NEC SV8500, Руководство пользователя

Страница: 413 / 3438

VOL.2-160
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
MAINTENANCE COMMAND FOR 8LC Card
The Maintenance Console uses the commands listed in.
COMMAND No. SUB COMMAND FUNCTION REMARKS
SETUP 1 SP SETUP COMMAND
COMMAND No. SUB COMMAND FUNCTION REMARKS
SET
1 BURSTPATTERN Setting Burst Ringer Pattern:
2 CH_ATTRIBUTE Setting Channel Attribute:
3 CID_SEND_WAIT Setting Caller ID Send Wait Timer:
4 CODEC_COEF Setting CODEC Coefficiency:
5 DEFAULTROUTE Setting Default Gateway:
6 DHCP Setting DHCP:
7 DNS_SW Setting DNS Server:
8 DSP_ECFB Setting DSP echo canceller for FAX communication:
9 EC_TRAINING Setting Training feature mode of echo canceller:
10 FAXERRORDETECT Setting FAX enable timer:
11 FAXRECVPAD Setting Fax receiver PAD value:
12 FAXSENDPAD Setting Fax sender PAD value:
13 HC_TIMER Setting Health Check Receive Timer
14 INTERFACE Setting the communication speed for LAN interface:
15 IPADDRESS Setting IP Address and Net Mask of 8LC Card:
16 MUSICTYPE Setting Internal Music-on-Hold type:
17 MW_LAMP Setting Message Waiting Lamp control type:
18 ONE_TIME_PASS Setting One Time Password for security:
19 OPEN Setting Open/Reverse mode:
20 OWN_NAME Setting Host Name of 8LC Card:
21 PAD Setting default receiver PAD value:
22 PRERINGING Setting Pre-Ringing:
23 RINGFREQ Setting frequency of Ringer:
24 SENDPAD Setting default sender PAD value:
25 SIGNALING_PORT_NO Setting signaling port number for SIP:
26 SIGNALING_QOS Setting QoS for SIP signaling session:
27 SIPSV_IPADDRESS
Setting IP address, port number, and host name of SIP serv-
er:
28 SMOOTH_PAD Setting DSP smooth PAD mode:
29 STARTPORT Setting RTP Start Port:
30 STUTTERDT Setting Stutter Dial Tone:
31 SYNCRINGING Setting Synchronous Ringer mode:
32 VLAN Setting VLAN:
33 WARNING_TONE Setting the Warning Tone for LAN failure: