NEC SV8500, Руководство пользователя

Страница: 2315 / 3438

VOL.2-2062
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
F
To set in dialog format (press Enter key after the sub command to skip entering P1 and P2):
• When TOS is selected in QoS setting, assign the data in IP Precedence type:
Note:
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
followed by the prompt. The meaning of 1-byte data for IP Precedence type of ToS field is shown below:
• When DIFFSERV is selected in QoS setting, enter the setting value in DSCP type:
Note:
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
followed by the prompt. The meaning of 1-byte data for Diffserv type of ToS field is shown below:
Note:
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
VS-32(SIP)> SET SIGNALING_QOS
QOS(TOS/DIFFSERV) [TOS]: TOS
Select TOS for QoS setting type [TOS/DIFFSERV]
(default=TOS)
PRECEDENCE (0-7:6): 6
Precedence: 0-7 (low-high) (default=6)
DELAY (0/1:0): 0
Delay: 0/1=Normal (default)/Low Delay ON
THROUGHPUT (0/1:0): 0
Throughput: 0/1=Normal (default)/High Throughput ON
RELIABILITY (0/1:0): 0
Reliability: 0/1=Normal (default)/High Reliability ON
COST (0/1:0): 0
Cost: 0/1=Normal (default)/Cost Precedence ON
Signaling QoS setting succeeded.(0xC0)
Result is shown.
VS-32(SIP)> SET SIGNALING_QOS
QOS (TOS/DIFFSERV:DIFFSERV): DIFFSERV
Select DIFFSERV for QoS setting type [TOS/
DIFFSERV]
DSCP (0-63:48): 48
Enter the setting value directly [0-63] (default=48)
Signaling QoS setting succeeded. (0xC0)
Result is shown.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Prec.
D T R C
DSCP DSCP = DiffServ Code Point (6 bits)