NEC SV8500, Руководство пользователя

Страница: 2525 / 3438

VOL.3-38
CHAPTER 1 TERMINALS
• When using the Bluetooth Handset, be sure to initialize the configuration data to the factory default setting.
To initialize the configuration data, follow procedures below.
STEP 1: When the Bluetooth Handset is in a standby status, press “HOLD”, “TRF”, “*”, and “#” in sequence.
STEP 2: When configuration menu for the Bluetooth Handset is displayed on LCD, use cursor key for “Up”
and “Down” to select “Factory Value”, and press “OK”.
Note:
After initialization, be sure not to change the configuration data.
(3) The following shows the service conditions specific to Wireless Headset (WT100-EHS-NE).
Wireless Headset (WT100-EHS-NE) enables you to answer a call, having a conversation, or disconnect the call
with hooking operations. The following diagram shows the example of a Wireless Headset connection.
Example of a Wireless Headset (WT100-EHS-NE) Connection
Note:
For the details on how to connect a telephone and Wireless Headset, see the manual attached to the Wire-
less Headset.
(1) Wireless Headset is available for DT300 Series (DT330). However, DT330 (DTL-32D-1) and DT330
(DTL-8LD-1) are not supported.
(2) Before using Wireless Headset, be sure to assign LKP=3 (32 Line/Feature Keys) with the ADKS command.
(3) Assign FKY=56 (Headset/Handset Key) to the Feature Key (FKY=25) by using the AKYD command.
(4) To activate a ringer tone when an incoming call arrives on the Wireless Headset, put an attached micro-
phone on the center of the telephone speaker. After the ringing tone (0.1 seconds or more ON/one second
or more OFF) is detected on the telephone, the ringing tone sounds from the headset. The ringing volume
must be set to 10 steps or more. The following diagram shows an example of a microphone connection.