NEC SV8500, Руководство пользователя

Страница: 1636 / 3438

VOL.2-1383
MG-SIP128 [MG-128SIPMGG]
Note 9:
When100Mbps (fixed) is selected, “Full Duplex” is automatically applied to the interface. There-
fore, this command line will not appear for interface that is specified as “100Mbps (fixed)”.
Note: Normally this command is not required to be changed.
(26) ipaddress
Setting of IP address and subnet mask
This command is used to set the number of ports MG-SIP128 [MG-128SIPMGG] uses, and assign an IP
Address and a subnet mask to each Ether port on MG-SIP128 [MG-128SIPMGG].
Ports of MG-SIP128 [MG-128SIPMGG] are allocated as follows;
• Ether1: LAN (Telephony Server network) side
• Ether2: WAN (SIP network) side
Note:
When “IPv6” is selected by “set ip_version” command, both of Ether1 and Ether2 ports are re-
quired because IPv6 packets are sent from/received to Ether2.
Note: When “IPv4” is selected by “set ip_version” command, and the IP addresses of both LAN and
WAN are assigned in the same segment, use Ether1 port only. Select one port in the number of port
setting, and assign Ether1’s IP address only. In this case, Ether2 is not used. For the MG-SIP128
[MG-128SIPMGG] where Ether2 is already registered, a message of “Ether[2]Port data is erased.
Are you sure? Y/N” is displayed. To delete the data of Ether2, enter Y.
[Setting Example]
[IPv6]
MG(SIP) > set ipaddress
Do you use one-port only? Y/N=n
Select “n” to use IPv6 function.
One-port only is not supported by IPv6 function.
Ether[1]
Setting Ether1 port:
Input IP Address.(default=0.0.0.0)
:10.1.0.1 IP address (Default: 0.0.0.0)
Input Subnet mask.(default=0.0.0.0)
:255.255.255.0
Subnet mask (Default: 0.0.0.0)
Setting Ether2 port:
Inputting Ether[2] setting data is unnecessary.
When IPv6 function is active (“IPv6” is selected
by “set ip_version” command), MG-SIP128 [MG-
128SIPMGG] can generate the IP address and the
Subnet mask for Ether2 by receiving the RA mes-
sage from the router.