NEC SV8500, Руководство пользователя

Страница: 804 / 3438

VOL.2-551
MG-COT Card [SCA-6COTA/SCA-6COTC]
• When DHCP server is used
As DHCP server automatically assigns IP addresses to MG-COT Card, Default Gateway, and the Telepho-
ny Server, there is no need to assign these network data on MG-COT Card side. IP addresses listed below,
however, have to be prepared in DHCP server side.
Note 1
• IP address of Default Gateway
• IP address and port number of DRS
Note 2
* Check the number of IP address saved in DHCP server is sufficient so as to get IP address of MG-COT
Card anytime.
Note 1:
DHCP option setting is as follows.
Class: Global
Name: Not specified, but do not enter the same option name in duplicate
Data: IP address
Array: Checked
Code: 161
Refer to DHCP Server in Volume 1 of this manual for more information on DHCP option setting.
Note 2:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
Note:
If DHCP server is set for use, DHCP option will be set for use automatically. (SP-3875 6MGCOT PROG-
A Ver.2.0.0.0 or later) If you do not assign the IP address of DRS to DHCP server, It must be assigned by
“SET DRSADDRESS” command individually.
Note:
Write down the displayed MG-ID (MAC address of MG-COT Card) to assign the MAC address on PCPro
command AMGIL and AISTL.
MG-COT> setup tp Input “setup tp” and press Enter key.
Note
MG-ID = xx:xx:xx:xx:xx:xx
MG-COT Card’s MAC address is displayed.
Use DHCP?
Input (Y:Yes/N:No/Q:Quit):y
Set whether to use DHCP server.
Input “y” here and press Enter key.
Note 2
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = ENABLE
--------------------------------------
Input (Y:OK / N:Change / Q:Quit):y Confirm the assigned data. Input “y” and press Enter key.
The assigned data is automatically saved and start re-
booting. The data turns effective after rebooting the MG-
COT Card.