NEC SV8500, Руководство пользователя

Страница: 1894 / 3438

VOL.2-1641
MG-SIP96
(23) hc_timer
Setting of health check timer value
This command is used to specify the health check time-out value.
[Setting Example]
Note:
Normally this command is not required to be changed.
(24) interface
Setting of the operation speed and operation mode of an interface
This command is used to assign the Ether speed and the duplex type to each port on MG-SIP96.
[Setting Example]
Note 2: When “Automatic Negotiation” is selected, “AUTO” is automatically applied to the interface.
Therefore, this command line will not appear for interface that is specified as “Automatic Negoti-
ation”.
Note 3: When100Mbps (fixed) is selected, “Full Duplex” is automatically applied to the interface. There-
fore, this command line will not appear for interface that is specified as “100Mbps (fixed)”.
Note:
Normally this command is not required to be changed.
MG(SIP)> set hc_timer
Input H/C timer value.(sec)
(130-65535(default=240)):240 Assign the Health Check timer value (Default: 240
seconds).
MG(SIP)> set interface
Select Ether[1] speed.
0=AUTO(default)
1=10M
2=100M
3=1000M
Input:0
Assign an Ether speed type to Ether 1.(Example:
when AUTO is set.)
0=Automatic Negotiation (Default)
1=10 Mbps (fixed)
2=100Mbps (fixed)
3=1000Mbps (fixed)
Note 3
Select “0”. Note 2
Select Ether[2] speed.
0=AUTO(default)
1=10M
2=100M
3=1000M
Input:1
Assign an Ether speed type to Ether 2.(Example:
when 100M/Full is set.)
0=Automatic Negotiation (Default)
1=10Mbps (fixed)
2=100Mbps (fixed)
3=1000Mbps (fixed)
Note 3
Select “1”.
Select Ether[2] duplex.
1=Half
2=Full
Input:2
Assign a duplex type to Ether 1 and Ether 2.
1=Half Duplex
2=Full Duplex
Select “2”.