NEC SV8500, Руководство пользователя

Страница: 975 / 3438

VOL.2-722
MG-BRI
bit0). The module needs to be reset or initialized after the System Data was modified by using the ADPM
command.
16. Re-routing following the LCR feature is performed if ISDN line or UDP/IP is faulty.
17. For Internal PHI-BRI, the port number used for MG-BRI can be changed using the ADTM command.
(Default: 64000). Changed data will be written into the System Data.
Operate the initialization following the procedure shown below after the port number has changed.
(Changed data will be effective after the initialization)
Note:
On the ADTM command setting, Internal PHI-BRI and Internal PHI-PRI share a common port number.
18. The value of QoS setting used for Internal PHI-BRI side will be the value assigned towards “LOC-
ID=0”(System) parameter of ALOCL command.
The value for the ToS (QoS) setting and Control Signal packet used for MG-BRI side will be the value
assigned with the AMGIL command.
The value for the Media stream will be the value assigned with the AMGVL command.
19. PAD value assigned for AMGVL command and AIVCL command takes precedence.
20. For Echo Canceller (EC) setting, value assigned for AMGVL command and AIVCL command takes pre-
cedence.
21. Echo Canceller (EC) training function is available between MG-BRI and ISDN network.
Note:
EC training feature: MG-BRI sends out the EC training tone to the ISDN network when station answered
a call to converge a echo on an early stage.
22. Used CODEC will be assigned with AMGVL command (value of AMVCL command is used when there
is nothing assigned for AMGVL command).
Data assignment of [Payload type]/[Payload size] needs to be assigned after confirming the setting condi-
tion of MG-BRI. (Contact your local NEC dealer for further information)
23. For “KIND” parameter of AMGIL command, choose [ISDN trunk (BRI)]
“LENS” of “LINE” and “CH” need to be assigned using the consecutive LENS.
(e.g. CH0=020010, CH1=020011...)
LENS: 000000 cannot be used.
24. In this feature, system side is responsible for timing control of call originating guard timer, which needs to
be assigned with the System Data (ASYD SYS1 Index474). Value “256ms” is default.
25. [S-127D] Serial Call - D cannot be operated towards the call terminating through the MG (BRI).
Command Operation menu Description of PHI Initialization
ADPM Module Initialize
Disconnects the PHI-BRI communication port and re-connect it
again.
Clears the MG information and sending-control information
(administrated by the PHI-BRI)
MG will be re-registered and all on-going communication will be
disconnected.