NEC SV8500, Руководство пользователя

Страница: 1019 / 3438

VOL.2-766
MG-BRI
11.7.4 Operation of Configuration Command
Configuration command is used just for modifying the default data. Data is to be modified only when it is
required and to the necessary part.
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. The Telephony
Server acts as DRS for MG-BRI using Proprietary Protocol.
Note:
When an event causing a restart of the device, such as health check timeout, occurs during startup of the
configuration command, it takes about five minutes to start the rebooting after you exit from the configu-
ration command or enter the last command.
By using the communication software such as HyperTerminal (
Note 1
), start a boot program by turning on
the power or pressing the reset switch.
When boot program has started, configuration command menu shown below appears by pressing the
“ESC” key while “Starting MG-BRI boot program” is displayed. Enter “1” and press the “RETURN” key.
Display change as follows. enter the command into this prompt to modify the configuration data.
Note 1:
Assign the communication setting of External Maintenance Terminal (PC) as follows.
11.7.5 Basic Command Entry
Displays the prompt of command interface, then displays the Reply message by analyzing the character
entered by the user. Command and Sub-command is mandatory, but Parameter vary depends on each Com-
mand. Example of Command, Sub-command and Parameter is shown below.
-<Boot mode>Main menu-
Configuration data. --- input:1
Quit
--------------- --- [Q/q]
Input:1
<Configuration data setting mode>
MG-BRI > ＿
Bits per second 9600 bps
Data bits 8 bits
Parity No
Stop bits 1 bit
Flow control No
Prompt Command Sub-command Parameter 1 (P1) Parameter 2 (P2)
MG-BRI> set own_ipaddress 123.201.18.45 255.255.255.0