Thermo Scientific Phadia 100, User Manual

Page: 22 / 357

Phadia 100 - User Manual Instrument Specification and Installation
12-3501-20/12 Page 1.19
1
1
NOTE! Phadia 100 must
only be connected to a
grounded power outlet
(protective ground).
8.
Take out the Sample
Carousel from the acces-
sory box. Place it on the
left side in front of the
bottles. The vial holders
and the sample holders
are in their positions.
9.
Choose the proper
mains kit to comply with
your mains voltage. You
find the mains kit and the
fuse kit in the accessory box.
10.
Select the correct mains kit.
Discard the unwanted kit imme-
diately. Remove the warning la-
bel covering the fuse/voltage se-
lector unit on the rear panel of
the instrument.
Open the fuse/voltage selector
cover using a screwdriver. Insert
the screwdriver at the top centre
and apply pressure.
11.
Turn the power on in order to open the processing chamber. The chamber
is opened by pressing the
lid open
key.
Place the enclosed fuses in the
fuse holders and install the fuse
holders in both the left and right
hand position. Remove the voltage selector
switch and select the correct
mains voltage by turning the
voltage selector. Place the
switch in the instrument. Close
the cover and make sure that
the selected voltage is visible
through the window. Connect
the main supply using the en-
closed cord.
6.
Remove the tape from
the Pipette Arm. Gently lift
the arm straight up and move
it to the right, away from the
Sample Carousel.
7.
Remove the tape from the Sample Carousel Cover and the tape
around the Rinse Solution, Washing Solution and Waste bottles.