Thermo Scientific Phadia 100, User Manual

Page: 117 / 357

Assay Run Editing Functions Phadia 100 - User Manual
P a g e 4 . 2 6 12-3501-20/12
Warnings that may prevent entering
NO QUALITY CONTROLS EXIST
There is no QC defined for the method.
10.
Select the Quality Control
you want to edit by pressing
no
until the desired Quality Con-
trol is displayed. Then press
yes
.
Set status
You can set the status to ACTIVE, INACTIVE or MANUAL. ACTIVE means
that the Quality Control will be added to all assay runs for the selected method,
INACTIVE means that the Quality Control will not be added and MANUAL
means that the Quality Control will be added if you decide so, when an assay
run is prepared.
1.
Press
yes
.
2.
Choose if the Quality
Control is to be set as ACTIVE,
MANUAL or INACTIVE by
pressing
no
until the desired
status is displayed. Then press
yes
. The status will be set.
Identity
The following step describes how you can change the identity of the Quality
Control.
1.
In Edit QC mode press
2
.
2.
Press
yes
.
3.
Delete or type over the
old Quality Control identity
and type the new identity (up
to eight characters). Press
en-
ter
to confirm this step.
5.2.9.2.Edit QC [sIgE]
Quality control: sIgE Pos d1?
5.2.9.2.Edit QC [sIgE/sIgE Pos]
1.Status?
5.2.9.2.Edit QC [sIgE/sIgE Pos]
Status: ACTIVE?
5.2.9.2.Edit QC [sIgE/sIgE Pos]
1.Status?
5.2.9.2.Edit QC [sIgE/sIgE Pos]
2.Identity?
5.2.9.2.Edit QC [sIgE/sIgE Pos]
Identity: sIgE Pos