Thermo Scientific Phadia 100, User Manual

Page: 161 / 357

Assay Run Quality Control Phadia 100 - User Manual
P a g e 6 . 1 0 12-3501-20/12
4.4.Edit Calibrators
Method: ImmunoCAP Specific IgE 0-100?
4.4.Edit Calibrators [sIgE]
1.Set Active Calibrators?
4.4.Edit Calibrators [sIgE]
2.Accept Calibrators?
4.4.1.Set Active Calibrators [sIgE]
sIgE calibrators: 060405 11:13 15?
Warnings that may prevent entering
NO CALIBRATORS EXIST
There are no stored calibrators for the selected method.
3.
Select the calibrators you
want by pressing
no
until the
ones you want appear, then
press
yes
.
The selected calibrators will be set as active for the method you pressed.
Messages that can occur
CAL TOO OLD TO ACTIVATE
The selected calibrators have been inactivated too long to be set to active
(compared to max. reactivate time set in method).
CAL NOT ACCEPTED, PROCEED ANYWAY?
The selected calibrators do not have the acceptance level OK. If you press
yes
the calibrators will be set to active, if you press
no
they will not be set to active.
Accept Calibrators
You can set the acceptance of calibrators to OK, FLAGGED or NOT OK. The
status OK indicates that the calibrators are suitable for evaluating an assay run.
The status FLAGGED indicates that one curve control was not within the limits
in the last run and now the calibration curve is uncertain for use. The status
NOT OK indicates that the calibrators cannot be used for evaluation. The
change of acceptance is permanent.
1.
In Edit Calibrators mode
press
no
until the method you
want appears, then press
yes
.
2.
Press
2
.
3.
Press
yes
.