RELEASE 3.02 FCP CONVERSION INSTRUCTIONS
14-26
Edition One
XC1000 Service
To resolve the error, perform the following steps:
a. At the error message screen, press the
Esc
key to quit the
FCP conversion and return to the
C:\FCP>
prompt.
Call the Octel National Response Center (for national
accounts) or the Octel Technical Assistance Center (TAC)
to assist you before attempting to resolve software-
incompatibility problems.
Caution!
b. Evaluate and correct the incompatibility problem(s) by
acquiring properly supported software (software diskettes
and/or phrase diskettes).
c.
Load the new software diskettes or phrase diskettes onto
the hard drive (section 14.7.3).
d. Begin the FCP conversion again (section 14.9, step 1).
After all checks have been completed, a screen similar to the one
shown in Figure 14-17 appears.
Final confirmation before conversion
==================================================
VPM serial : 12345
will be converted to
Software release: 3.02
Continue the conversion(Y/N): Y
Press <Enter> to continue. Press <Esc> to quit.
Figure 14-17. Example of Final Confirmation
Before Conversion Screen.
12. If the information in the Final confirmation before conversion screen
(Figure 14-17) is correct, press the
Enter
key. The !!!INSTRUCTION!!!
screen shown in Figure 14-18 appears, to make sure that ports have
been disabled and validity checks and garbage collect have been run.
13. At the
Have you done these steps already (Y/N):
prompt, the default
Y
is highlighted. If the steps described in Figure 14-18 (sections 14.4
and 14.6) were performed previously, press the
Enter
key to accept
the default
Y
and proceed to step 14.
SECTION 14.9
Summary of Contents for XC1000
