Octel XC1000, Service Manual

Page: 93 / 889

PLATFORM INSTALLATION
3-29 Edition One XC1000 Service
3. Connect one end of the the keyboard cable to the receptacle on the
back of the keyboard. Connect the other end to the receptacle labeled
KEYBD on the back of the terminal.
4. Connect and secure the RS-232-C DB25 cable labeled DATACOMM to
the DATACOMM port on the back of the terminal.
5. Connect the other end of the RS-232-C cable to the J50 connector on
the XC1000 main distribution board (refer to Figure 3-15).
6. Connect the slotted end of the power cord to the power receptacle on
the back of the terminal base.
7. Make sure that there is a grounded 120-Vac power outlet (NEMA type
3–14R) within reach of the power cord, but do not plug the terminal
in at this time.
3.10.2 Printer Installation
Currently, Octel supports the Fujitsu DL1200 and the Okidata Microline
320 (ML320) printers. Other printers can be used with the proper adapta-
tions. For other printer use, contact the manufacturer’s representative.
Perform the following steps to install either of the supported printers:
1. If the printer has not been unpacked, carefully remove the printer
from its container. Save all packing materials, in case the printer
must be returned. For specific instructions about unpacking and the
physical setup of the printer, refer to the supplied printer user
manual.
2. Place the printer next to the SMT on a sturdy table or desk within 50
feet of the XC1000. Make sure the printer is within 10 feet of the
SMT.
3. Depending on the terminal installed, use one of the following cables:
-
For an HP 700/43 terminal, use P/N 057–1149–000.
- For a Wyse 50 terminal, use P/N 058–1089–000.
- For the DEC VT102 or VT220, refer to the DEC user’s manual
for the correct cable required.
-
For any other terminal, refer to the supplied terminal user’s
manual.
4. Connect and secure one end of the cable to the printer adapter, as
follows:
-
On the right side of the DL1200 printer.
-
On the back of the ML320 printer.
5. Connect the other end of the printer cable to the auxiliary port on the
back of the terminal.
6. Plug the printer’s power cord into a 120-Vac power receptacle.
SECTION 3.10