Octel XC1000, Service Manual

Page: 416 / 889

SYSTEM UTILITIES
9-33 Edition One XC1000 Service
Do not run garbage collect with the master drive installed.
If garbage collect is run with the master drive in system-
drive-slot 0 (S0), all messages will be lost.
Caution!
Perform the following steps to run garbage collect:
1. Coordinate with the system manager before taking the XC1000 out of
service.
2. Disable all multiline hunt groups and SMDI links going to the XC1000
by using one of the following methods:
Divert the pilot number of the multiline hunt group.
Remove the Amphenol connectors from the SMDI connections on
the main backplane.
Disable all line tasks in menu 4.
3. Type
^C
twice to return to the SMT Main Menu.
4. If a data module is connected to the XC1000, the X.25 link must be
stopped before running garbage collect. From the Main Menu, select
option
18 for X.25 Interface Management.
5. From menu 18, select option 3 for X.25 Interface Operation. Menu
18.3 appears, as shown in Figure 9-11.
Menu 18 – X.25 Interface Management
– Interface Operation –
Physical Interface Number: 0
Enter “1” – Start, “2” – Immediate Stop:
Enter the number of the operation you wish to perform.
Press “Break” to enter a new Physical Interface Number.
Interface Status
––––––––– ––––––
0 PHYSICAL (L1) STARTED
Figure 9-11. Menu 18.3, Interface Operation.
6. In the Physical Interface Number: field, enter the number of the
XC1000 DB25 connector to which the X.25 link is connected and
press the
Enter
key. Valid interface numbers are
0
and
1
.
7. In response to the prompts at the bottom of the screen in menu 18.3,
type 2 for Immediate Stop and press the Enter key. Press ^C or the
Break key until the Main Menu reappears.
SECTION 9.7