Octel XC1000, Service Manual

Page: 68 / 889

PLATFORM INSTALLATION
3-4 Edition One XC1000 Service
3.2.3 Environmental Safety
The XC1000 must operate within safe environmental parameters. Environ-
mental requirements are described in section 2.4.
The XC1000 depends on the positive air pressure created by the air flow
within the cabinet to maintain the temperature within operating limits. The
card cage and the disk-drive bays constitute part of an air plenum. Verify
that blank slot and drive panels, which are shipped with and installed in
the XC1000, are in the empty slots in the card cage and in the disk-drive
bays to prevent air leakage. The slot and drive panels are required for
environmental air and electromagnetic-interference (EMI) control.
3.3 OBTAINING REQUIRED TOOLS
The following tools are required to uncrate, assemble, and install either a
single-cabinet or a dual-cabinet XC1000:
-
Crowbar or claw hammer
-
Screwdrivers
-
Phillips-head, no. 2
-
flat-blade, medium
-
Wrenches
-
socket,
9
/
16
-inch drive
-
socket,
1
/
2
-inch drive
- open-end,
9
/
16
-inch
-
3
/
8
-inch, L-type Hex key (supplied in floor-mount kit)
- torque, socket,
1
/
2
-inch drive (recommended)
-
Sockets,
7
/
32
-inch hex bit,
1
/
2
-inch,
9
/
16
-inch, and
3
/
4
-inch
-
Voltmeter, 75-Vdc scale minimum
-
Ohmmeter, 10-megohm minimum
-
Power and grounding cabling, 2 AWG or larger
-
Cable ties
-
Crimp-ring lugs, 2-AWG, 5/16-inch stud (optional)
-
Conduit and fittings, 1
1
/
4
-inch (optional)
-
Crimp or swage tool (optional)
The following tools are required for a concrete-floor installation:
-
Concrete bit,
1
/
2
-inch, carbide tip
-
Roto hammer
-
Hammer
The following tools are required for a raised-floor installation:
-
Drill bit,
1
/
2
-inch
-
Drill
No bolts, nuts, or washers are provided for installing the floor-mount angle
brackets on a raised floor.
SECTION 3.2 – 3.3