ROUTINE MAINTENANCE
5-11
Edition One
XC1000 Service
5.6 MEASURING POWER AND GROUND
The power and ground should be measured monthly. To check the power
and ground, perform the following steps:
1. Open the rear doors of the XC1000.
2. Locate the +5-Vdc and +12 Vdc-test points on the main distribution
board, as shown in Figure 5-5. Voltage test points for +5 Vdc and +12
Vdc are located at the lower right corner of the main distribution
board. The test points are TP1 (return), TP2 (+5 Vdc), and TP3 (+12
Vdc). A second set of test points is located at the lower middle of the
board. These test points are labeled TP6 (return), TP7 (+5 Vdc), and
TP8 (+12 Vdc), and are provided for cabinet 2 in a dual-cabinet
configuration.
DISTRIBUTION BOARD
FOR CABINET 2 ONLY
TP8, RETURN
TP3, +12 VDC
J43
J44
J45
J46
J47
J48
J49
J50
TP2, +5 VDC
TP1, RETURN
TP7, +5 VDC
TP6, +12 VDC
FOR CABINET 1
S1
S2
Figure 5-5. Main Distribution Board, Showing the Location of
+5-Vdc and +12-Vdc Test Points.
Avoid contact with the –48 Vdc bus bar and terminals.
Contact with –48 Vdc can cause personal injury.
Warning!
3. Remove the cover to the power-distribution shelf.
4. Locate the + and – points for the –48 Vdc power supply, as shown in
Figure 5-6. Using a voltmeter, measure across the + and – points.
Verify that the power source supplies 43 to 56 Vdc. When the positive,
SECTION 5.6
Summary of Contents for XC1000
