Octel XC1000, Service Manual

Page: 708 / 889

RELEASE 4.X FCP CONVERSION INSTRUCTIONS
17-22 Release 4.X XC1000 Service
If Aspen/Maxum/Branch/XP:
1. Connect COM1 to physical port 3 (logical channel 4).
2. Connect COM2 to physical port 1 (logical channel 2).
If Sierra/XC1000:
1. Connect COM1 to port J50 (logical channel 4).
2. Connect COM2 to port J43 (logical channel 2).
Press <Enter> to continue.
!!! INSTRUCTION !!!
Figure 17-60. Instruction Screen for Verifying
Cable Connection.
12. Press Enter .
13. The script (FCP conversion program) starts running. If the cabling
between the PC and the XC1000 was not done properly, if the SMT
password was entered incorrectly, or if the XC1000 was not at the
SMT Main Menu when it was disconnected, an error screen shown in
Figure 17-61 appears. If the error screen does not appear, proceed to
step 14.
If the error screen does appear, press Enter . If the error screen does
not reappear, proceed to step 14.
If the error screen reappears, press Esc to terminate the FCP conver-
sion and return to the DOS C:\FCP> prompt.
SMT port is not connected,
password is not correct, or the VPM is not on–line.
Press <Esc> to quit. Press <Enter> to retry.
Figure 17-61. Error Screen.
If the cabling between the PC and the XC1000 was not done
properly, do the following:
a. Repeat the steps listed in section 17.8.
b. At C:\FCP> , type fcpconv and press Enter .
c. At the FCP conversion Main Menu (Figure 17-49), select
option
2. Perform/Continue Conversion and press
Enter . When the screen displays the “... Stopped at
stage #: 10 Continue the Conversion (Y/N): Y” prompt,
press Enter to continue. The conversion resumes from
the point where the failure occurred.
SECTION 17.9