Octel XC1000, Service Manual, Page: 346 / 889

REPAIR AND REPLACEMENT
8-39 Edition One XC1000 Service
ENTER B, THEN A TO BOOT.
ENABLE SERVICE OPTION.
SHUT DOWN SYSTEM
(MENU 13.1.1).
TURN OFF SYSTEM POWER.
PLACE NEW DRIVE IN
APPROPRIATE MSG
DRIVE SLOT.
TURN ON SYSTEM POWER.
ENTER INSTALL OPTIONS
(^DI).
CHOOSE OPTION
D - INITIALIZE DRIVE.
INITIALIZE DRIVE Mx
AS MSG DRIVE.
CHOOSE OPTION
A - INSTALL DRIVE.
CHOOSE OPTION
X - EXIT.
ENTER ^DT TO
ENTER DRIVE TEST.
SELECT LONG TEST,
SINGLE TIME.
CHECK MENU 12.
RETURN TO
NORMAL OPERATION.
Figure 8-18. Installing an Additional Message Drive.
8.4.12.1 Installing the New Message-Drive Module. Complete the following steps
to install the new drive module in the cabinet and in system software:
1. Call the Octel Communications Technical Assistance Center and
request that the service option be enabled.
2. Shut down the XC1000 using menu 13.1.
3. When the
ENTER BOOT COMMAND:
prompt appears, turn off power
to the XC1000.
4. Insert the new message-drive module in the appropriate message drive slot.
5. Turn on power to the XC1000.
6. Type
^DI
at the
ENTER BOOT COMMAND :
prompt to enter the
INSTALL OPTIONS: menu.
7. Select D for the initialize-drive option. Initialize the new drive as a
message drive by answering the prompts as shown below:
SELECT DRIVE TO INITIALIZE (1, M0-M7): Mx
DRIVE Mx SELECTED
CONTINUE (Y OR N)? Y
DRIVE INITIALIZED
SELECT DRIVE TO INITIALIZE (1, M0-M7):
where
x
is the number of the slot where the new message drive is
placed.
8. When the SELECT DRIVE TO INITIALIZE (1, M0-M7): prompt appears
after the new message drive is initialized, type ^C to return to the
INSTALL OPTIONS: menu, unless additional drives need to be initialized.
9. Enter A to select the install-drive option. At the SELECT DRIVE TO
INSTALL (1, M0-M7):
prompt, type
Mx
, where
x
is the number of the
drive slot where the new message drive is placed.
SECTION 8.4