Mindray TE5, Operator'S Manual

Page: 249 / 323

Probes and Biopsy 13-49
b) Introduce a needle into the cap, and ensure that the needle tip contacts the bottom of the
needle cap.
c) Hold the needle for 1 or 2 seconds and then withdraw it quickly from the magnetizer.
NOTE: if the needle cap associated with the needle does not meet the requirements, you are
recommended to use BBraun Sterican < 35mm needles cap or B&D Microlance < 35mm
needles cap.
13.4.5 Procedure
NOTE: 1. The Pan Zoom function is not supported on eSpacial Navi mode.
2. Do not freeze the ultrasound image during the procedure. Otherwise, biopsy
guidance information will disappear.
3. When the insertion angle of a needle relative to the skin surface exceeds 60°,
is displayed at the right side of on screen to notify users to adjust the angle.
After the angle is smaller than 60°, disappears.
Perform the following steps.
1. Hold the probe stably and put the needle close to the probe for connection. After the needle
and probe are successfully connected, the system automatically calculate the maximum depth
at which the needle can be detected in real time, and display the depth value in the touch
screen.
NOTE: when the actual depth is greater than the maximum value, the needle guidance
information disappears temporally.
Adjust the needle position and angle to define the position for inserting the needle. Pay attention to
the field strength during the needle guidance process.