Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 297 / 1488

pppoe sessions
Syntax
pppoe sessions sessions
no pppoe sessions
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Specifies the number of subinterfaces permitted on a PPPoE interface. The command
affects only subinterfaces that are created
after the command is entered. Previously
created interfaces remain, even if their number exceeds the new value of the
parameter. The
no version restores the default value, 8000 (ERX routers) and 16,000
(E120 and E320 routers). For ES2 10G ADV LM, the default value is 32,000 (E120
and E320 routers).
Options
■
sessions —Number of subinterfaces permitted on the interface in the range 1–8000
(ERX routers) or 1–32,000 (E120 and E320 routers). On the ES2 10G ADV LM
(E120 and E320 routers), you can have PPPoE subinterfaces in the range
1–32,000. The default value is 8000 (ERX routers) or 16,000 (E120 and E320
routers). For ES2 10G ADV LM, the default value is 32,000 (E120 and E320
routers).
NOTE: The number of subinterfaces permitted on the interface for E120 and E320
routers is in the range 1–32,000 irrespective of the type of line module. However, if
you specify a value greater than the number of subinterfaces supported by a line
module, the number of subinterfaces created is the default maximum value for that
line module. For example, if you specify the number of subinterfaces for a ES2 4G
LM as 32,000 interfaces, the number of subinterfaces created is 16,000, which is the
default maximum value for the ES2 4G LM.
Mode
Interface Configuration, Profile Configuration, Subinterface Configuration
pppoe sessions
■ 255
Chapter 4: P Commands