Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 182 / 1488

path ds1|e1 description
Syntax
path pathChannel { ds1 | e1 } tributaryIdentifier [ tributaryType ] description name
no path pathChannel { ds1 | e1 } tributaryIdentifier [ tributaryType ] description
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Assigns a text description or an alias to a DS1 or an E1 signal. This command applies
to a DS1/E1 over SONET/SDH VT layer on channelized SONET and SDH interfaces.
Use the
show controllers sonet command to display the text description. The no
version removes the description or alias.
Options
■
pathChannel —Number, in the range 1–2147483648, that identifies the path
■
tributaryIdentifier —Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload / tributaryGroup / tributaryNumber
■
pathPayload —Payload number for the path; value is 1 for SONET and in the
range 1–3 for SDH
■
tributaryGroup —Number, in the range 1–7, that identifies the group within
the path
■
tributaryNumber —Number of the tributary within the tributary group; the
value is in the range 1–4 if the tributary type is vt15 or tu11 and in the range
1–3 if the tributary type is tu12
■
tributaryType —Virtual tributary type
■
vt15—Default for SONET DS1 tributaries
■
tu11—Default for SDH DS1 tributaries
■
tu12—Default for SDH E1 tributaries
■
name —Text string or alias of up to 80 characters for the T1/E1 over SONET/SDH
VT layer on channelized SONET and SDH interfaces
Mode
Controller Configuration
140 ■
path ds1|e1 description
JUNOSe 11.1.x Command Reference Guide N to Z