Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 197 / 1488

path ds3 equipment loopback
Syntax
path pathChannel ds3 ds3Channel equipment { customer | network } loopback
no path pathChannel ds3 ds3Channel equipment
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Enables or disables the router’s ability to be placed in loopback by a remote device
connected at the DS3 layer for a DS3 signal. This command applies to a DS3 over
channelized SONET interface. The
no version restores the default behavior, which
disables the router’s ability to be placed in loopback by a remote device. Using the
no version has the same effect as issuing the command with the network keyword.
Options
■
pathChannel —Number, in the range 1–2147483648, that identifies the path
■
ds3Channel —Number, in the range 1–3, that identifies the path
■
customer—Enables the router to start loopback testing when it receives an
appropriate signal from the remote interface
■
network—Disables the router’s ability to start loopback testing when it receives
an appropriate signal from the remote interface; this is the default behavior
Mode
Controller Configuration
path ds3 equipment loopback
■ 155
Chapter 4: P Commands