Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 153 / 1488

oam retry
Syntax
oam retry [ upRetryCount [ downRetryCount retryFrequency ] ]
no oam retry
Release Information
Command introduced in JUNOSe Release 7.1.0.
ATM VC Class Configuration mode added in JUNOSe Release 7.3.0.
Description
In ATM VC Configuration mode, configures parameters for F5 OAM VC integrity on
an ATM PVC. The
oam retry command is valid only for data PVCs; you cannot use
this command for control (ILMI or signaling) PVCs. The no version restores the default
values for all of these parameters.
In ATM VC Class Configuration mode, configures F5 OAM VC integrity parameters
as part of a VC class definition that you assign to an ATM PVC. The
no version restores
the default values for all of these parameters in the VC class.
NOTE: To configure the up retry count, down retry count, and retry frequency F5
OAM VC integrity parameters, you must use the oam retry command. There is no
equivalent atm pvc command to configure these parameters.
Options
upRetryCount —Number of successive loopback cell responses, in the range 1–60,
for the router to receive before reporting that a PVC is up; default value is 3
■
■
downRetryCount —Number of successive loopback cell responses, in the range
1–60, for the router to miss before reporting that a PVC is down; default value
is 5
■
retryFrequency —Number of seconds, in the range 1–600, for the router to wait
between the transmission of loopback cells when it is verifying the state of the
PVC; default value is 1
Mode
ATM VC Configuration, ATM VC Class Configuration
oam retry
■ 111
Chapter 3: O Commands