Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 1442 / 1488

vc-class atm
Syntax
[ no ] vc-class atm vcClassName
Release Information
Command introduced in JUNOSe Release 7.3.0.
Description
Creates and names a VC class for an ATM data PVC. This command accesses ATM
VC Class Configuration mode, from which you can configure a set of attributes for
an ATM data PVC. The VC class can include attributes for the service category,
encapsulation method, F5 OAM options, and Inverse ARP. You then apply the
attributes as a group by assigning the VC class to an individual PVC, to all PVCs
created on a specified ATM major interface, to all PVCs created on a specified
ATM 1483 subinterface, or to a base profile from which bulk-configured VC ranges
are dynamically created. The
no version removes the named VC class from the router.
You cannot remove a VC class that is currently assigned to at least one ATM PVC,
ATM 1483 subinterface, or ATM major interface without first issuing the
no class-vc
command or the no show ip dhcp-local binding command to remove the VC class
association with the PVC, interface, or subinterface.
NOTE: For information about the total number of ATM VC classes supported on the
router, see JUNOSe Release Notes, Appendix A, System Maximums .
Options
■
vcClassName —Name of the VC class; a string of up to 32 alphanumeric characters
Mode
Global Configuration
1400 ■
vc-class atm
JUNOSe 11.1.x Command Reference Guide N to Z