Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 1383 / 1488

configured. If you specify the destination address, it must be the address of the MPLS
interface or the router ID of the destination router. The
no version deletes the
endpoints.
Options
■
ipAddress1 —IP address of the interface on the remote router
■
hostname —Name of the host to serve as the tunnel endpoint
■
ipAddress2 —IP address of the tunnel destination address subnet
■
mask —IP mask of the tunnel destination address subnet
■
ipAddressLow —First IP address in a destination address range
■
ipAddressHigh —Last IP address in a destination address range
■
ipAddress3 —IP address of the interface on the remote router or the router ID of
the destination router that serves as the tunnel endpoint
■
fqdn —Fully qualified domain name of the interface on the remote router that
serves as the tunnel endpoint; a maximum of 80 characters
■
isis-level-2—Specifies IS-IS level-2 routers as acceptable destinations
■
ospf-bdr—Specifies OSPF border routers as acceptable destinations
■
listName —Name of access list or prefix list that contains the IP addresses that
are acceptable as tunnel endpoints
■
ipAddress4 —IP address of the interface on the remote router or the router ID of
the destination router that serves as the tunnel endpoint; for a tunnel profile,
you can list multiple addresses
■
*—Indicates that one or more parameters can be repeated multiple times in a
list in the command line
Mode
Interface Configuration, IP Tunnel Destination Profile Configuration, Tunnel Profile
Configuration
tunnel destination
■ 1341
Chapter 8: T Commands