Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 1254 / 1488

speed
Syntax
For console sessions:
speed baudRate
no speed
For Ethernet interfaces on line modules:
speed speedValue
no speed
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
When used from Line Configuration mode, sets the speed for the current and all new
console sessions immediately. The
no version reverts to the default value, 9600 bps.
When used from Interface Configuration mode, specifies the line speed for an Ethernet
interface. This command works with the
duplex command; if you set or accept the
automatically negotiate setting for either duplex mode or speed, the router negotiates
both parameters with the remote device. The
no version specifies the default,
automatically negotiate or 100 Mbps (FE-8 SFP I/O module only). This command is
not available for the Ethernet interface on the SRP module.
Options
baudRate —Terminal speed for the current console session; one of the following
values: 2400, 4800, 9600, 14400, 19200, 28800, 38400, 57600, 115200
■
■
speedValue —Line speed; one of the following values:
■
automatically negotiate—Specifies that the router negotiates the line speed
with the remote device; not valid for the FE-8 SFP I/O module
■
10—Specifies that the router uses a line speed of 10 Mbps on a Fast Ethernet
interface; not valid for Gigabit Ethernet interfaces or the FE-8 SFP I/O module
■
100—Specifies that the router uses a line speed of 100 Mbps on a
Fast Ethernet interface; not valid for Gigabit Ethernet interfaces
■
1000—Specifies that the router uses a line speed of 1000 Mbps on a
Gigabit Ethernet interface; not valid for Fast Ethernet interfaces
Mode
Interface Configuration, Line Configuration
1212 ■
speed
JUNOSe 11.1.x Command Reference Guide N to Z