Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 89 / 1488

neighbor maximum-prefix
Syntax
neighbor { ipAddress | ipv6Address | peerGroupName } maximum-prefix maximum
[ threshold ] [ strict ] [ warning-only ]
no neighbor { ipAddress | ipv6Address | peerGroupName } maximum-prefix
[ maximum ][ threshold ] [ strict ] [ warning-only ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
ipv6Address variable added in JUNOSe Release 8.0.0.
Description
Sets the number of prefixes that can be received from a neighbor. The no version
removes the maximum prefix limitation.
Options
■
ipAddress —IP address of BGP neighbor
■
ipv6Address —IPv6 address of BGP neighbor
■
peerGroupName —Name of the BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
■
maximum —Maximum number of prefixes; default value is no limit
■
threshold —Percent of maximum at which to log a warning in the range 0–100;
default value is 75
■
strict—Checks the maximum prefix limit against all received routes rather than
the default behavior of checking it only against accepted routes
■
warning-only—Causes BGP software to log a warning, rather than reset the
connection if the
maximum or threshold value is exceeded
Mode
Address Family Configuration, Router Configuration
neighbor maximum-prefix
■ 47
Chapter 2: N Commands