Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 1342 / 1488

threshold
Syntax
threshold { sd-ber | sf-ber } rate
no threshold { sd-ber | sf-ber }
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Sets the threshold values for bit error rates used in APS/MSP alarms. This command
applies only to the protect interface, and not to the working interface. The
no version
restores the default value, 5 (for the sd-ber bit error rate) or 3 (for the sf-ber bit error
rate), for the specified alarm.
Options
sd-ber—Bit error rate that specifies signal degradation
■
■
sf-ber—Bit error rate that specifies signal failure
■
rate —Integer n with available values depending on the bit error rate type you
specify; a value of n corresponds to a rate of 10- n (10e- n ) errors per second
■
For sd-ber, an integer in the range 5–9; default value is 5
■
For sf-ber, an integer in the range 3–5; default value is 3
Mode
Controller Configuration
1300 ■
threshold
JUNOSe 11.1.x Command Reference Guide N to Z