Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 543 / 1488

set-overload-bit
Syntax
[ no ] set-overload-bit [ on-startup seconds | on-startup wait-for-bgp
[ bgpSeconds ] ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Sets the overload bit, indicating to other IS-IS routers not to use this router as an
intermediate hop in their SPF calculations. The
no version restores the default value,
clearing the overload bit.
Options
■
on-startup—Sets the overload bit only after a system reload; prevents other
routers from routing through this router before it is fully operational
■
seconds —Period after the reload during which the overload bit is set, in the range
5–86400 seconds; the overload bit is cleared when the period expires
■
wait-for-bgp—Specifies that the overload bit is not cleared until BGP has
completed convergence
■
bgpSeconds —Maximum period to wait for BGP to converge, in the range 5–86400
seconds with a default value of 600 seconds; the overload bit is cleared when
the period expires
Mode
Router Configuration
set-overload-bit
■ 501
Chapter 7: S Commands