Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 1257 / 1488

srp switch
Syntax
srp switch [ [ force ] [ reason ] ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Switches from the primary SRP module to the standby. This command is equivalent
to the
redundancy force-switchover command with the srp option. There is no no
version.
NOTE: When the high availability state is active, this command does not take effect
until all transaction data, up to when you issue the command, has been mirrored to
the standby SRP module. This behavior preserves legacy behavior that requires SRP
modules to be synchronized before the switchover.
Options
force—Prompts the user to confirm that the router should switch from the primary
SRP module to the standby if the SRP modules are in certain states, such as
■
writing configuration data to NVS, that could lead to loss of configuration data
or corruption of NVS
■
reason —Reason for the change
Mode
Privileged Exec
srp switch
■ 1215
Chapter 7: S Commands