Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 173 / 1488

path
Syntax
path pathChannel [ pathSpeed [ pathHierarchy ] ]
no path pathChannel
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Configures paths over channelized SONET and SDH interfaces. The no version deletes
a path.
NOTE: Although the path speed appears to be optional in the software, you must
specify a value.
Options
pathChannel —Number, in the range 1–2147483648, that identifies the STS-1 or
STM-0 line
■
■
pathSpeed —Speed of the path
■
oc1, oc3, or oc12 for SONET—Only oc1 is available for cOC3/STM1 interfaces
■
stm0, stm1, or stm4 for SDH—Only stm0 or stm1 is available for cOC3/STM1
interfaces
■
pathHierarchy —Identifier that defines the structure of the path
■
If you specify a path speed that matches the speed of the module (for
example, a path speed of stm1 for a cOC3/STM1 interface), do not specify
an identifier.
■
If you specify a speed of oc1 or stm0 for a cOC3/STM1 interface, the identifier
is a number, in the range 1–3, that represents either the STS-1 within the
STS-3 or the STM-0 within the STM-1.
■
If you specify a speed of stm1 for a cOC12/STM4 interface, the identifier is
a number, in the range 1–4, that represents the STM-1 within the STM-4.
■
If you specify a speed of oc1 or stm0 for a cOC12/STM4 interface, the
identifier is of the form X/Y. X is a number, in the range 1–4, that represents
either the STS-3 within the STS-12 or the STM-1 within the STM-4; Y is a
number, in the range 1–3, that represents either the STS-1 within the STS-3
or the STM-0 within the STM-1.
Mode
Controller Configuration
path
■ 131
Chapter 4: P Commands