Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010, Command Reference Manual

Page: 911 / 1488

show ip tunnel-route
Syntax
show ip tunnel-route [ vrf vrfName ] [ destination [ ipMask ] [ detail ] ]
[ all ] [ protocol ] [ filter ]
Release Information
Command introduced in JUNOSe Release 7.1.0.
Description
Displays current state of the IPv4 tunnel routing table.
Options
■
vrfName —Contents of the IPv4 tunnel routing table associated with a VRF
■
destination —IP address or domain name of the host to show
■
ipMask —IP mask of the specific address to show
■
detail—Displays detailed information about the specific prefix
■
all—Displays all routes in the IPv4 tunnel routing table inserted from all protocols,
not just the best routes
■
protocol —One of the following protocols for which you want to display the best
route or all routes in the tunnel routing table; no routes are displayed if routes
for the specified protocol are not present in the tunnel routing table
NOTE: Other protocol options are available in the CLI, but they are not applicable to
the tunnel routing table.
■
bgp-tunnel—Displays the BGP tunnel routes in the tunnel routing table
■
ldp—Displays the LDP tunnel routes in the tunnel routing table
■
rsvp—Displays the RSVP tunnel routes in the tunnel routing table
■
filter —See Filtering show Commands on page 4
Mode
Privileged Exec, User Exec
show ip tunnel-route
■ 869
Chapter 7: S Commands